TREE

Using the LMZ14202H power switching controller, can be designed a very simple switching power supply circuit that can provide a fixed output voltage covering a wide range of voltages . Switching Power Supply Circuit diagram This power switching power supply electronic project will provide a fixed output voltage between 5 and 30 volt from an input voltage between 8 and 42 volt at a maximum output current of 2 ampere . This circuit project power supply require few external electronic parts and can be configured very easy . In the table bellow you can see components value that are required for different output voltage

There are only a limited number of switching regulators designed to generate negative output voltages. In many cases, it’s thus necessary to use a switching regulator that was actually designed for a positive voltage in a modified circuit configuration that makes it suitable for generating a negative output voltage. The circuit shown in Figure 1 uses the familiar LM2575 step-down regulator from National Semiconductor (www.national.com). This circuit converts a positive-voltage step-down regulator into a negative-voltage step-up regulator. It converts an input voltage between –5 V and –12 V into a regulated –12-V output voltage. Note that the output capacitor must be larger than in the standard circuit for a positive output voltage. The switched current through the storage choke is also somewhat higher. Some examples of suitable storage chokes for this circuit are the PE-53113 from Pulse (www.pulseeng.com) and the DO3308P-153 from Coilcraft (www.coilcraft.com). The LM2575-xx is availabl...

                     Above circuit diagram is a easy, simple and cheap switching voltage regulator which has capability to deliver adjustable voltage output range of 1.8V to 32V and static electric current of 3A. This regulator use adjustable regulator IC of LM317HV and a power PNP transistor of 2N3792. The LM317HV is adjustable 3-terminal positive voltage regulators capable of supplying in excess of 1.5A over a 1.2V to 57V output range. This electronic component exceptionally easy to use and require only two external resistors to set the output voltage. Further, both line and load regulation are better than standard fixed regulators. Also, the LM317HV is packaged in standard transistor packages which are easily mounted and handled. LM317HV Features: Adjustable Output Down to 1.2V Specified 1.5A Output Current Line Regulation Typically 0.01%/V Load Regulation Typically 0.1% Current Limi...

This is a Simple Soft Start For Switching Power Supply Project. Switching power supply whose output voltage is appreciably lower than its input voltage has an interesting property: the current drawn by it is smaller than its output current. However, the input power (UI) is, of course, greater than the output power. There is another aspect that needs to be watched: when the input voltage at switch-on is too low, the regulator will tend to draw the full current. When the supply cannot cope with this, it fails or the fuse blows. It is, therefore, advisable to disable the regulator at switch-on (via the on/off input). until the relevant capacitor has been charged. When the regulator then starts to draw current, the charging current has already dropped to a level which does not overload the voltage source. Soft Start For Switching Power Supply Circuit diagram: Soft Start Circuit For Switching Power Supply The circuit in the diagram provides an output voltage of 5 V and is supplied by a 24 V...