High Power Amplifier

This circuit of power amplifiers using a booster 8 sets sanken , the buffer using transistor D400 and B560 as much 2 sets , and to use part of the driver transistor B546/A940 and D401/C2168. And least 20 volts and the voltage to 70 volts maximum with three voltage is +,-,ground. Power Output 2 X 600 Watt with 8 Ohm Impedance.

Circuit audio amplifier 600 Watt

Circuit of PCB so from 2 X 600 watts (looked down)

Circuit of PCB (looked upon)

The above is a circuit of ready to operate , just stay put booster.

Source : link

Comments

A basic Arduino Solar PV Monitor

I have just recently had solar pv installed, mainly to future proof my energy costs, I do not expect it to be like drilling for oil in my back garden, however the return looks to be encouraging. The install gives you another single unit meter, from this you will see the total amount the panels produce, but that is about it. I wanted to know how much the production was as it was happening, I discovered the light blinks on the front of the meter will flash 1000 times for each kWh of electricity which passes through. The rate of the flashing of the LED tells you how much power is currently passing through the meter. [ ]

8 Problem soluation

This post is under progress

Schematic Audio Amplifier with IC AN7102S

This Schematic use IC AN7102S , this is setereo amplifier and have output speaker 7,5 mW with impedance 32 Ohm . Supply need 1Volt to 3 Volt , wow this amplifier low voltage. You can use this amplifier on radio is use battery . With just one battery with voltage 1,5 Volt you can play this amplifier. See this Schematic below : Click to Enlarge Datasheet IC AN7102S Vcc = 1-3 V Pout = 2X 7,5 mW RL = 32 Ohm Ft = 20hz - 20Khz Icco = 7 mA Package = DIP-18 Manufactered = MATSUSHITA

TREE

Search This Blog