Tizen first phone with Android and independence

Samsung has been showing prototypes of different phones with Tizen and so far is that finally presents the first phone with Tizen, the Samsung Z.

Why be so important this phone? The reason is that the operating system Tizen Samsung has been developing for a little while longer and intended to help the company to not depend so much on Android, as it currently does. Additionally, the Samsung Gear 2, Gear 2 and Gear Neo Fit, devices were the first company to have this operating system.

The Samsung Z is just a start, then do not expect it to do wonders or win all the awards.

The new Samsung phone has a 4.8-inch AMOLED display with 720p resolution, a quad-core 2.3GHz processor (possibly Intel), 2GB of RAM, 16GB of storage with support for micro SD card, an 8 megapixel rear camera, a front 2.1 megapixel camera, a sensor for detecting the heart rate and fingerprint reader.

Additionally, the Samsung Z has a 2,600 mAh battery and has dimensions of 138.2 s x 69.8 x 8.5 mm.

The first phone with Tizen, Samsung Z, released in black and gold in the coming weeks with a price that has not been announced and beginning in Russia.

Comments

3 Channels Audio Splitter Amplifier Circuit Diagram using TL084

This is the schematic diagram of 3 channels audio splitter amplifier circuit which built using op-amp IC TL084. The 3 channels amplifier output distribution applies a single TL084. 3 Channels Audio Splitter Amplifier Circuit Diagram The very first step is to capacitive coupling having a p. 1.0 ~ electrolytic capacitor. The entries are railways Vee Y2 or 4.5 V. This enables working with an individual 9V power source. A voltage gain of 10 (1 M?/100 Kohm) is obtained in the first stage, as well as the other three floors are connected as a unity gain voltage followers. Every single output stage drives independently through an amplifier output 50 pF capacitor towards the resistance of 5.1 k ohm load. The response range is flat from 10 Hz to 30 kHz.

Simple Automatic Street Light

There have been lot of problems in street lights. Major problem in some places is every evening a person has to come and switch ON the street light and it should be again switched off in morning. Yes, this may not be the situation in everywhere but exists in many places. So this problem can be overcome by using a simple circuit. Below shown circuit will be automatically switched ON and OFF during night and morning times respectively. Circuit diagram : Simple Automatic street light Circuit Diagram In above circuit R1 can be used to adjust the sensitivity. And the working of the circuit is very simple. The LDR will have very low resistance during day time so the transistor Q1 will be in OFF condition. And during night time the resistance will be very high so automatically the transistor Q1 will be ON. The Q1 is PNP transistor and the emitter of Q1 is given to base of Q2. So the Q2 transistor will be ON only if the transistor Q1 is ON. The TRIAC is used in the circuit to make is circ...

A basic Arduino Solar PV Monitor

I have just recently had solar pv installed, mainly to future proof my energy costs, I do not expect it to be like drilling for oil in my back garden, however the return looks to be encouraging. The install gives you another single unit meter, from this you will see the total amount the panels produce, but that is about it. I wanted to know how much the production was as it was happening, I discovered the light blinks on the front of the meter will flash 1000 times for each kWh of electricity which passes through. The rate of the flashing of the LED tells you how much power is currently passing through the meter. [ ]

TREE

Search This Blog