Skip to main content

35W Bridge Power Amplifier with TDA2030


This is the schematic diagram of 35W bridge power amplifier circuit, delivers 35W power output for 8? speaker. The circuit is similar to this 15W bridge amplifier. It use two pieces of amplifier IC TDA2030 (you may use LM1875 as subtitute/replacement).

 Build a 35W Bridge Power Amplifier with TDA2030

Build a 35W Bridge Power Amplifier with TDA2030


Notes:
  • Use 15V/3A power supply for maximum performance.
  • Use heatsink to prevent overheating on the IC
Parts List:
R1,3,5,7,9 = 22K?
R2,8 = 680?
R4,6 = 1?
C1 = 4.7uF/16V
C2,7 = 22uF/16V
C3,6 = 220nF
C4,9 = 100nF
C5,8 = 200uF/25V
IC1-2 = TDA2030 / LM1875
Lsp = 8?/ 60W Loudspeaker



Comments

Popular posts from this blog

A basic Arduino Solar PV Monitor

I have just recently had solar pv installed, mainly to future proof my energy costs, I do not expect it to be like drilling for oil in my back garden, however the return looks to be encouraging. The install gives you another single unit meter, from this you will see the total amount the panels produce, but that is about it. I wanted to know how much the production was as it was happening, I discovered the light blinks on the front of the meter will flash 1000 times for each kWh of electricity which passes through. The rate of the flashing of the LED tells you how much power is currently passing through the meter. [ ]

Schematic Audio Amplifier with IC AN7102S

This Schematic use IC AN7102S , this is setereo amplifier and have output speaker 7,5 mW with impedance 32 Ohm . Supply need 1Volt to 3 Volt , wow this amplifier low voltage. You can use this amplifier on radio is use battery . With just one battery with voltage 1,5 Volt you can play this amplifier. See this Schematic below : Click to Enlarge Datasheet IC AN7102S Vcc                   =  1-3 V Pout                 = 2X 7,5 mW RL                    = 32 Ohm Ft                      = 20hz - 20Khz Icco                  = 7 mA Package         = DIP-18 Manufactered = MATSUSHITA

3 Channels Audio Splitter Amplifier Circuit Diagram using TL084

This is the schematic diagram of 3 channels audio splitter amplifier circuit which built using op-amp IC TL084. The 3 channels amplifier output distribution applies a single TL084.   3 Channels Audio Splitter Amplifier Circuit Diagram The very first step is to capacitive coupling having a p. 1.0 ~ electrolytic capacitor. The entries are railways Vee Y2 or 4.5 V. This enables working with an individual 9V power source. A voltage gain of 10 (1 M?/100 Kohm) is obtained in the first stage, as well as the other three floors are connected as a unity gain voltage followers. Every single output stage drives independently through an amplifier output 50 pF capacitor towards the resistance of 5.1 k ohm load. The response range is flat from 10 Hz to 30 kHz.