Skip to main content

Procyon – 80 MHz ARM Cortex M3 with SDRAM Ethernet SD USB


Procyon is a general purpose development board with special features for Ethernet, USB, and audio applications. It is based on Luminary Micro/Texas Instruments LM3S9x9x series of parts. The initial MCU is LM3S9B90.

The board contains the following features:
  • 80 MHz, 100 Pin Cortex M3 Processor
  • 16 MB SDRAM accessed on a 50 MHz EPI bus
  • USB Host/Device/OTG port
  • microSD card slot (Attached to SSI1/SPI1)
  • 10/100 Ethernet
  • I2S header for DAC output interface
  • Up to 24 GPIOs available
  • 3 UART, 2 I2C, 1 CAN, 2 SPI/SSI (one shared with microSD card)
  • 10-bit ADCs
  • General purpose timers: four 32-bit or eight 16-bit
  • FTDI/Basic UART debug/program interface, on 16 pin GPIO/configuration header
  • Three 10 pin headers for daughter boards
  • 20 Pin JTAG Header
  • User LED and User switch [ ]

Comments

Popular posts from this blog

A basic Arduino Solar PV Monitor

I have just recently had solar pv installed, mainly to future proof my energy costs, I do not expect it to be like drilling for oil in my back garden, however the return looks to be encouraging. The install gives you another single unit meter, from this you will see the total amount the panels produce, but that is about it. I wanted to know how much the production was as it was happening, I discovered the light blinks on the front of the meter will flash 1000 times for each kWh of electricity which passes through. The rate of the flashing of the LED tells you how much power is currently passing through the meter. [ ]

Schematic Audio Amplifier with IC AN7102S

This Schematic use IC AN7102S , this is setereo amplifier and have output speaker 7,5 mW with impedance 32 Ohm . Supply need 1Volt to 3 Volt , wow this amplifier low voltage. You can use this amplifier on radio is use battery . With just one battery with voltage 1,5 Volt you can play this amplifier. See this Schematic below : Click to Enlarge Datasheet IC AN7102S Vcc                   =  1-3 V Pout                 = 2X 7,5 mW RL                    = 32 Ohm Ft                      = 20hz - 20Khz Icco                  = 7 mA Package         = DIP-18 Manufactered = MATSUSHITA