Skip to main content

Power Supply with High Voltage Isolation


Occasionally you come across some unusual  situations when setting up measurement  systems. The author once had to set up a system to register the vibrations and strain supposed to be  present in a contactor that operated at a voltage of 25 kVAC.

Power Supply with High Voltage Isolation Circuit Diagram: 

Power Supply Circuit Diagram

One of the biggest problems with this project turned out to be the power supply for  the measurement system. Since it required  a power of about 30 W it wasn’t possible to  use batteries since the system had to operate  for many hours at a time. A logical solution  would seem to be to use an isolating trans-former, but still.25 kVAC means a peak volt-age approaching 40 kV, and on top of that  you would have to include a safety margin. In  addition, everything that is connected to high  voltage lines should also be able to withstand  lighting strikes!

Consequently the isolation should be able to  cope with a test voltage of 150 kV, which is a  lot to ask of the isolating material.

After extensive research no supplier could be  found for a transformer rated at 50 W, 230 V  primary, 12 V secondary and an isolation of  25 kVAC. Because of this, a dynamic system  had to be used that unfortunately suffers a  bit from wear and tear. This system consists  of a 50 W 3-phase motor connected up via an  isolating drive-shaft to a 30 W generator (a  3-phase servo motor that was used as a generator), which provides the power for the data  logger and associated electronics.

Because a 3-phase generator was used, the  voltage obtained after full-wave rectification (via D1 and D4 to D8) already looked good,  also because the revs of the generator was  fairly high. The secondary supply can there-fore remain fairly simple. The main supply of 9 VDC is stabilised by IC3, an LM317T. From  there it is fed to a few small DC/DC modules  (IC1, IC4, IC5), which supply voltages of +5 V,  +30 V and -9 V, which are required by the other parts of the circuit. IC2 (LM566, a volt-age controlled oscillator) makes LED D2 flash  when the supply voltage is present.


Comments

Popular posts from this blog

A basic Arduino Solar PV Monitor

I have just recently had solar pv installed, mainly to future proof my energy costs, I do not expect it to be like drilling for oil in my back garden, however the return looks to be encouraging. The install gives you another single unit meter, from this you will see the total amount the panels produce, but that is about it. I wanted to know how much the production was as it was happening, I discovered the light blinks on the front of the meter will flash 1000 times for each kWh of electricity which passes through. The rate of the flashing of the LED tells you how much power is currently passing through the meter. [ ]

Schematic Audio Amplifier with IC AN7102S

This Schematic use IC AN7102S , this is setereo amplifier and have output speaker 7,5 mW with impedance 32 Ohm . Supply need 1Volt to 3 Volt , wow this amplifier low voltage. You can use this amplifier on radio is use battery . With just one battery with voltage 1,5 Volt you can play this amplifier. See this Schematic below : Click to Enlarge Datasheet IC AN7102S Vcc                   =  1-3 V Pout                 = 2X 7,5 mW RL                    = 32 Ohm Ft                      = 20hz - 20Khz Icco                  = 7 mA Package         = DIP-18 Manufactered = MATSUSHITA